The window repair is carried out onsite and does not require removing the glass from the frame. You can be assured that there is no dust or mess. Much of the work is done from the outside but on occasions we may need to operator from inside.The repair requires the installation of a micro venture filter on the surface of the glass over a 3mm hole. This filter is discreetly positioned in the corner of the window. The results will be a clear window. The thermal pane window behaves like a miniature greenhouse. Air between the glass expands and contracts with the temperature of the sunlight. This in turn pumps air in and out of your windows. The window seal is semi-permeable and therefore not actually hermetically sealed. During manufacturer of the windows water absorbing desiccant pellets are placed in the rim of the window to prevent moisture. After time these pellets stop working and in turn moisture builds up between the panes. Defog Windows Dublin use a patented process with the micro filters re-balance the windows so that more water exits than returns. Our process will permanently solve the problem, restoring the insulating value. The sooner the window is repaired, the better the results. All standard windows can have the moisture removed. However, if the unit has been wet for a long time, mineral deposits may have formed on the inside glass surfaces.. The glass may have some water spots caused by weather. Most of these are removable using our patented process. If mineral deposits have been on the glass for an extended period they may have etched the inside surface of the glass. This is a permanent condition that, so far, cannot be reversed.
How Defog Windows Dublin restores the glass
Our trained technicians arrive equipped with specialized tools and equipment. All service work is done on site, with a minimum of disruption and disturbance. Glass unit are most often services from the exterior. Our technician will inspect each piece of glass individually and advise the customer of the condition and expected results after restoration.Using a specially made high speed diamond drill with lubrication, two very small holes are drill in the outside glass at one lower and one upper corner. All service work is done through these holes. The inside of the unit is rinsed and washed and rinsed again with several specialized cleaners to remove dirt, water spots and mineral scale. If necessary tiny scrapers will be inserted through the hole to scrape away any dirt and mineral scale not removed by our cleaning solution. The unit interior is then rewashed and rinsed and finally our patented micro vents are installed over the previously drilled holes.Our micro vents allow the air pressure and humidity to equalize between the interior of the glass unit and outside. This prevents moisture from accumulating and condensing inside the unit and has been recognized and proven as the solution to moisture between panes of glass for many years. Our restoration process is a modern adaptation of a proven technology and is the permanent solution to the problem of failed insulating glass units.